D2009 Install?
Posted: Sun Sep 14, 2008 4:35 pm
Hi
Is it possible to install the latest version into D2009?
I tried running the setup.exe and it reports no errors.
However, the design package is listed but unchecked in the IDE Install Packages dialog.
Attempting to check it generates an error about missing bpl.
Attempting to compile/install the .dpk fails with the following error message:
---------------------------
bds.exe - Entry Point Not Found
---------------------------
The procedure entry point @Sysutils@StringReplace$qqrx20System@UnicodeStringt1t149System@%Set$t21Sysutils@SysUtils__15$iuc$0$iuc$1% could not be located in the dynamic link library rtl120.bpl.
---------------------------
OK
---------------------------
Am I doing something wrong .. or .. ?
Is it possible to install the latest version into D2009?
I tried running the setup.exe and it reports no errors.
However, the design package is listed but unchecked in the IDE Install Packages dialog.
Attempting to check it generates an error about missing bpl.
Attempting to compile/install the .dpk fails with the following error message:
---------------------------
bds.exe - Entry Point Not Found
---------------------------
The procedure entry point @Sysutils@StringReplace$qqrx20System@UnicodeStringt1t149System@%Set$t21Sysutils@SysUtils__15$iuc$0$iuc$1% could not be located in the dynamic link library rtl120.bpl.
---------------------------
OK
---------------------------
Am I doing something wrong .. or .. ?